None 33624 Guía de instalación descargar pdf

How to Install Oak Counter Trim

Place the length of trim on the countertop edge exactly where it will be installed. Carefully mark the back side of the

trim where cuts will be needed using the edge of the countertop as a guide (Figure 1). Use a miter box with a sharp,

fine-toothed saw to cut the trim as marked.

Insert the trim upside down in the miter box and place the saw in the guides needed to make the appropriate cuts for

45° inside and outside corners. A sharp, fine-toothed saw helps to reduce splintering. Lightly sand any rough edges.

Try to avoid splicing trim pieces together along visible parts of the countertop. If it is necessary to splice exposed

trim, miter the joining pieces at a 45° angle to give the best appearance and get the tightest fit. (Figure 2).

1 2 3

Pagina 1

How to Install Oak Counter Trim Place the length of trim on the countertop edge exactly where it will be installed. Carefully mark the back side of t

To give a professional look to trim installation, drill pilot nail holes straight through the beveled trim edge with a bit slightly smaller than your

Before applying stain to installed trim, test penetration and color of stain on a scrap piece of counter trim. When satisfied with color, brush the w

Sin comentarios

None 33624 Guía de instalación